Flywheel resurfacing

g3integragsr · Post by **g3integragsr** » Sat Sep 01, 2007 7:45 pm

Im swapping transmissions in my car on monday and I have a lightweight flywheel im putting in with it. My problem is that no shops are open until tuesday to get it resurfaced, so what can I do to maybe clean it up myself? It doesnt have any surface rust on it, I didn't feel it slip at all when I drove the car but I want to be on the safe side and maybe clean it up a bit. Can I just use some 1,000 grit sandpaper and lightly sand down the face of it?

Gunmetal Si · Post by **Gunmetal Si** » Sun Sep 02, 2007 1:53 am

orielys can do it if they have the tool to get the pins out

g3integragsr · Post by **g3integragsr** » Sun Sep 02, 2007 8:51 pm

GUNMETAL SI;64124 wrote:orielys can do it if they have the tool to get the pins out

I called O'riellys and they said they don't do it. Anyone else have an input on this?

Waffles · Post by **Waffles** » Sun Sep 02, 2007 8:52 pm

Call up most any repair shop, they will do it or have someone that does it for them.

Gunmetal Si · Post by **Gunmetal Si** » Sun Sep 02, 2007 9:06 pm

kinda odd since they did a flywheel for me.....

g3integragsr · Post by **g3integragsr** » Sun Sep 02, 2007 9:07 pm

GUNMETAL SI;64243 wrote:kinda odd since they did a flywheel for me.....

I called the one off salt lick road in Saint Peters and they said they only resurface brake rotors