Anyone make wheels spacers?

muha22752 · Post by **muha22752** » Thu Dec 08, 2011 11:10 pm

looking for some to make me some wheel spacers. 20mm
I know, thats alot but the offset on these new wheels sucks. lool, spacers will be cheaper than anything else for now.

eh2_Erik · Post by **eh2_Erik** » Thu Dec 08, 2011 11:21 pm

You'll need extended wheel studs if you're planning on spacing out 20mm. Or buy bolt on spacers. The offset will change substantially if you buy wider barrels tho. So you must figure out the Final offset will calculate out to.

muha22752 · Post by **muha22752** » Thu Dec 08, 2011 11:48 pm

yap, just want to see it someone can make them for me rather than buying them off of the web. I already have it offset figured out. 20mm buring me to 49mm difference from my esm's.

delslo · Post by **delslo** » Fri Dec 09, 2011 12:02 am

I used plywood

muha22752 · Post by **muha22752** » Fri Dec 09, 2011 12:23 am

I was thinking about duck tape, but plywood might work.

Capt'n Obvious · Post by **Capt'n Obvious** » Sat Dec 10, 2011 6:35 am

ebay sells extended studs and 20mm spacers as a set and also probly have 1 inch with studs in em that are held onto your stock studs with lugnuts

i have 8mm thats the largest i would go on stock studs