cut a top hat?

crx08 · Post by **crx08** » Thu Mar 11, 2010 7:16 pm

I have tried to cut these top hats I pulled from a junkyard since GC doesn't make extended top hats for the accords. I was using a hack saw for 20-30 mins and got no where. any one have any other suggestions on a quicker way to cut it off? or maybe have access to a band saw?

Waffles · Post by **Waffles** » Thu Mar 11, 2010 8:33 pm

Grinder + cut off disk.

99PreludeSh · Post by **99PreludeSh** » Thu Mar 11, 2010 8:35 pm

Waffles;224768 wrote:Grinder + cut off disk.

just about to post that. If you need a grinder to borrow let me know I have one.

crx08 · Post by **crx08** » Thu Mar 11, 2010 11:13 pm

Waffles;224768 wrote:Grinder + cut off disk.

good thinking

99PreludeSh;224770 wrote:just about to post that. If you need a grinder to borrow let me know I have one.

I might when I get time.

Post by **stolle** » Fri Mar 12, 2010 5:30 pm

hole saw just a little bit bigger than the top.

either that or just get one the same size as the tubing your going to use perfect round hole to weld on

Capt'n Obvious · Post by **Capt'n Obvious** » Sat Mar 13, 2010 1:28 am

fuck gc i got mine off ebay for 50 bux see if they make em for accords