rear sway bar problems

CourtesyFlush · Post by **CourtesyFlush** » Mon Jul 13, 2009 10:40 pm

got new blox LCA's and the rear sway bar doesnt fit up to it. i got a GSR. what do i do?

Waffles · Post by **Waffles** » Mon Jul 13, 2009 10:41 pm

In waht way isnt it fitting? Is it even close? Have you called blox to make sure you got the correct part number?

Phate · Post by **Phate** » Tue Jul 14, 2009 1:18 am

Theyre not intended to be used with the stock endlinks, or a stock swaybar for that matter.. but you can make it work. You just gotta buy some high grade long bolts and nuts, pull the endlinks until they line up and shove the bolts in. I did it, and it works fine.... so far.

Midori · Post by **Midori** » Tue Jul 14, 2009 3:37 am

yeah the sway bar mounts at the top of the LCA stock where as most aftermarket LCAs make it mount in the center of the LCA if you buy skunk2's or Function7's you wont have this problem other wise do what phate said or buy an aftermarket or type R rear sway bar and get the proper endlinks

CourtesyFlush · Post by **CourtesyFlush** » Tue Jul 14, 2009 2:38 pm

ok thanks. and until then, if i dont connect the sway bar and just use my car as a dd, it wont hurt nothin will it??

Gunmetal Si · Post by **Gunmetal Si** » Tue Jul 14, 2009 2:40 pm

lol. no it wont. will jsut drive even shittier than it did before.

on a side not. my stock endlinks bolted right up mine...........