crx issues

User avatar
91beatuphatch
Posts: 484
Joined: Wed Aug 18, 2010 1:15 am

crx issues

Post by 91beatuphatch »

90 crx hf d16z6 w/ hf trans- header, short ram, exhaust no cat


my timing belt has slack. while rotating the crank to check the timing the belt would tighten and slack back out. as if one side tight other side loose. is the belt streched? i do have a new gates belt on standby.


my other question is: i noticed my car running rich. im having random idle surges, only getting 220 miles per tank, and a blatent fuel smell with smoke from exhaust. ive checked for vac leaks and fixed what i found, installed new plugs, wires etc, fuel filter, o2. any ideas on where to go next? also there are no cel codes.
JustRob
Posts: 7884
Joined: Sat Nov 18, 2006 7:28 pm

crx issues

Post by JustRob »

Try adjusting the tension first. With the engine cold, remove the valve cover and upper timing belt cover. Set the No. 1 piston at TDC. Loosen the timing belt tensioner adjusting bolt 180°. Rotate the crankshaft counterclockwise 3-teeth on the camshaft pulley to create tension on the timing belt. Make sure the timing belt and the camshaft pulley are engaged securely. Torque the timing belt tensioner adjusting bolt to 33 Ib-ft. After adjusting, retorque the crankshaft pulley bolt to 134 Ib-ft.

Always rotate the crankshaft counterclockwise when viewed from the pulley side. Rotating it clockwise may result in improper adjustment of the belt tension.

If the timing belt still has excessive slack, I would remove the timing belt and timing belt tensioner and inspect them for wear.

As for the poor fuel economy, what ECU are you using? When you fill up after driving 220 miles, how much fuel are you putting in the tank to bring it back to full? Do you still have the FITV, Charcoal Canister and Purge Solenoid?
User avatar
91beatuphatch
Posts: 484
Joined: Wed Aug 18, 2010 1:15 am

crx issues

Post by 91beatuphatch »

fitv is still there and charcol canister and purge solenoid have been bypassed. and i know my gas guage is off about a gallon or so. i think i usualy put 8 gallons in it. ecu is p28.
User avatar
91beatuphatch
Posts: 484
Joined: Wed Aug 18, 2010 1:15 am

crx issues

Post by 91beatuphatch »

bump
User avatar
gcef89
Posts: 481
Joined: Sat Apr 09, 2011 4:54 am

crx issues

Post by gcef89 »

try cleaning your iac and fitv they can cause idle surges. and are u smelling the fuel smell inside of your car? or out by the exhaust?
User avatar
CRX91
Posts: 612
Joined: Sat Aug 01, 2009 7:30 am

crx issues

Post by CRX91 »

The gas gauge is like 2 1/2 gallans off I for got to tell u that
User avatar
91beatuphatch
Posts: 484
Joined: Wed Aug 18, 2010 1:15 am

crx issues

Post by 91beatuphatch »

it doesnt seem that far off but i knew it was. and i smell gas from exhaust. with a little smoke at idle. people behind me while driving say they smell it from a distance.
User avatar
CRX91
Posts: 612
Joined: Sat Aug 01, 2009 7:30 am

crx issues

Post by CRX91 »

I did tell u that it has the obd0 injectors and u should swap it to the obd1 injectors that mite help some of the lacking power problems ur having
User avatar
91beatuphatch
Posts: 484
Joined: Wed Aug 18, 2010 1:15 am

crx issues

Post by 91beatuphatch »

yes you did but i was wondering if i put obd1 injectors in wouldnt i have to bypass the resistor box? im lost with it.
User avatar
CRX91
Posts: 612
Joined: Sat Aug 01, 2009 7:30 am

crx issues

Post by CRX91 »

Yea I think you would have to but I'm not 100% sure