Stackable Head Gasket

remoer · Post by **remoer** » Wed Jun 06, 2007 5:04 am

SilverStreak;47306 wrote:Ummm...wrong. If you remove the middle layer you RAISE compression, not lower it.

yes my bad, it's raise up. .. wow a screw up i usally don't do those but oh well thanks for the correction.

JustRob · Post by **JustRob** » Wed Jun 06, 2007 5:06 am

remoer;47380 wrote:yes my bad, it's raise up. .. wow a screw up i usally don't do those but oh well thanks for the correction.

NP, its easy to get that confused.

bildo16 · Post by **bildo16** » Wed Jun 06, 2007 11:07 am

i understand the concept, i just wouldnt stack one on top of the other, even if thats what its made for.

JustRob · Post by **JustRob** » Wed Jun 06, 2007 9:19 pm

bildo16;47421 wrote:i understand the concept, i just wouldnt stack one on top of the other, even if thats what its made for.

You know factory head gaskets use the same concept right? :lol2:

dclduke · Post by **dclduke** » Wed Jun 06, 2007 9:20 pm

With the one from Mr. Gasket I could get anywhere from 9.4:1 to 8.05:1.