jdm badge problem

Daddy_Danglez · Post by **Daddy_Danglez** » Wed Jan 12, 2011 7:44 pm

Hey I drive a bb6 prelude SH, ordered Honda badges (red) just got them in. The front one fits but the back one isn't even remotely close.. I compared the stock ones and it looks like the prongs on the back are a little wider than the front. But the jdm ones I have the back is smaller. I know that the EP3 front badge fits the front. I'm not sure nor can't seem to find anything about the back badge. Any thoughts?

99BlackHatch · Post by **99BlackHatch** » Wed Jan 12, 2011 8:34 pm

What badges did you order?

for an EP3? or for Prelude? or what...

Daddy_Danglez · Post by **Daddy_Danglez** » Wed Jan 12, 2011 9:56 pm

Well I couldn't find them anywhere. I finally searched bb6 Honda badge. and found it. this was before the fact I knew the ep3 fits.

JustRob · Post by **JustRob** » Wed Jan 12, 2011 11:24 pm

I don't think Honda ever made a 'Red H' badge for these cars.

Post by **budget_crx** » Wed Jan 12, 2011 11:40 pm

JustRob;253622 wrote:I don't think Honda ever made a 'Red H' badge for these cars.

werd, they were reserved for Type Rs. Any prelude badges would have to be aftermarket.

Daddy_Danglez · Post by **Daddy_Danglez** » Thu Jan 13, 2011 12:14 am

okay budget.. that mugen picture is hott as Fuck! Lolz
Any way what if I just cut the prongs and stuck them on Lolz ghetto but Idk I have these badges with no use now

Phate · Post by **Phate** » Thu Jan 13, 2011 12:16 am

wht01_lude_SH;253628 wrote:okay budget.. that mugen picture is hott as Fuck! Lolz
Any way what if I just cut the prongs and stuck them on Lolz ghetto but Idk I have these badges with no use now

Then your nicer prelude would be ghetto. If thats what you want to do.. its your car. But there wasnt a Prelude Type-R. There was a Type-S, however.

99PreludeSh · Post by **99PreludeSh** » Thu Jan 13, 2011 2:40 am

I heard sometimes the badges don't fit because the car isn't "JDM" enough

ymisoqt · Post by **ymisoqt** » Thu Jan 13, 2011 3:30 am

I laffed

Fenian · Post by **Fenian** » Thu Jan 13, 2011 3:37 am

wht01_lude_SH;253612 wrote:Hey I drive a bb6 prelude SH, ordered Honda badges (red) just got them in. The front one fits but the back one isn't even remotely close.. I compared the stock ones and it looks like the prongs on the back are a little wider than the front. But the jdm ones I have the back is smaller. I know that the EP3 front badge fits the front. I'm not sure nor can't seem to find anything about the back badge. Any thoughts?

You could always use a Dremel to cut off the prongs and use 3M foam tape to put the rear one on. Just an idea.