01 ITR: Bumble Bee Build Thread Part TWO

[andyjt]

Nope... Don't know how else you could have taken my comment. I didn't know since you spaced it down if you had to raise the suspension to compensate, that is if you are on coil overs... I don't know your current setup on the Integra.

Glad to see that you got it all to work out and congrats

I spaced down the mounts and subframe equally to keep the engine/ axle angles the same. It sits about 1.5in lower than before. I plan on compensating the height differences through the coilovers.

What i thought you meant, was reffering to the fact the car was on jack stands, overexadurating how big the engine was and how much i had to lower it to make it fit.

[02Type-S]

Fucking awesome Andy! :partydance:

[xslickwhitetegx]

fucking sick Andy! Cant wait to see it inperson

[99BlackHatch]

I spaced down the mounts and subframe equally to keep the engine/ axle angles the same. It sits about 1.5in lower than before. I plan on compensating the height differences through the coilovers.

What i thought you meant, was reffering to the fact the car was on jack stands, overexadurating how big the engine was and how much i had to lower it to make it fit.

Andy, you know more than some how interested in this swap I am. Nothing I asked was for my humor. It was in serious interest and to learn what needs to be done.

Once again, congrats on getting it done.


Also, I was simply asking with my original comment if you had to raise the suspension maybe 3/4" - 1" in order for clearance from the ground to oil pan since you spaced the engine down lower, that is all, just to clarify... not jack stands or anything

[andyjt]

Andy, you know more than some how interested in this swap I am. Nothing I asked was for my humor. It was in serious interest and to learn what needs to be done.

Once again, congrats on getting it done.


Also, I was simply asking with my original comment if you had to raise the suspension maybe 3/4" - 1" in order for clearance from the ground to oil pan since you spaced the engine down lower, that is all, just to clarify... not jack stands or anything

Blah. Okay. Anything else Just ask me at bbt or something. im ready to pass out from Black friday all night shopping

[Capt'n Obvious]

i spot a new mani

[99BlackHatch]

What manifold did it take to get it to close properly?

NOTE : Serious question. lol

[Its Pat!]

there you fucking go

[sharpie]

What manifold did it take to get it to close properly?

NOTE : Serious question. lol

09 tl manifold

[99BlackHatch]

I read it as he installed another manifold...

I cut the webbing, swapped manifolds and lowered everything down 1.5in. The oil pan wont scrape. There is PLENTY of clearance.

When I read that I assumed this was everything he had done that day... implying that he swapped on another new manifold from elsewhere