whats wrong with this picture?

HardCore97 · Post by **HardCore97** » Wed Feb 11, 2009 1:25 am

wow someone is REALLY retarded

JustRob · Post by **JustRob** » Wed Feb 11, 2009 1:54 am

Wow! You're doing it wrong LOL

Gunmetal Si · Post by **Gunmetal Si** » Wed Feb 11, 2009 1:55 am

what a way to throw 300 bucks into the trash. i take it those are from a d16y8?

HardCore97 · Post by **HardCore97** » Wed Feb 11, 2009 1:58 am

idk what they are from. some guy just posted that and asked if they could still be used

sharpie · Post by **sharpie** » Wed Feb 11, 2009 2:11 am

lol i wonder what that sounded like

N2HIFI · Post by **N2HIFI** » Wed Feb 11, 2009 2:38 am

guess somebody did not know about notching their block

99SilverCX · Post by **99SilverCX** » Wed Feb 11, 2009 3:41 am

laugh at me all you want, but I want to be sure I'm on the same page with you...
... I'm noticing that the rods have a dents in them on the crank end, i'm assuming they were straight when new...

Waffles · Post by **Waffles** » Wed Feb 11, 2009 3:49 am

99SilverCX;164134 wrote:laugh at me all you want, but I want to be sure I'm on the same page with you...
... I'm noticing that the rods have a dents in them on the crank end, i'm assuming they were straight when new...

Yes they were solid. Most aftermarket rods are a little wider than stock and you have to notch the bottom of the block to put them in. I am going to guess he left the crank at TDC when putting them in. never cranked the engine to check for clearance.

16vshelbyz · Post by **16vshelbyz** » Wed Feb 11, 2009 4:44 am

Wow just when you think people can't get any dumber they have to go and do something like that.

Midori · Post by **Midori** » Wed Feb 11, 2009 5:26 am

LOL awesome