Polk and JL and LED Gauge Failure oh my 56k = ouch

kikkinasphalt · Post by **kikkinasphalt** » Fri Jan 09, 2009 3:40 am

so.
i had my sub and amp's installed by Chris (N2HIFI)
below are the results.

what we have here is

Custom Fiberglass trunk box (spare tire well)
JL 300.2 amp, Kenwood 700x4
Polk MOMO 12 inch sub.

i agree that the gap by the amp rack looks silly, we will be fixing this shortly.

now for my LED Gauge Failure.

i had these blue LED's (194's) floatin around. so i thought "heck, throw em in your gauges". well the results are a 5/10. i can see the numbers fine.. but the needles are a PITA to see. dont know if anything can be done here, might just go back to the ol white bulbs.

(the Oil Press Sending unit is not hooked up yet)

Gunmetal Si · Post by **Gunmetal Si** » Fri Jan 09, 2009 3:45 am

werd son

Phate · Post by **Phate** » Fri Jan 09, 2009 4:59 am

Why is the gap inbetween the amps silly?

kikkinasphalt · Post by **kikkinasphalt** » Fri Jan 09, 2009 5:03 am

Phate;157822 wrote:Why is the gap inbetween the amps silly?

the ap on the edge. where you can see the seat back

Phate · Post by **Phate** » Fri Jan 09, 2009 5:09 am

SLOSHONOGO;157823 wrote:the ap on the edge. where you can see the seat back

Ah, I was thinking the gap between the amps.. lool.

orange94hatch · Post by **orange94hatch** » Fri Jan 09, 2009 5:59 am

very nice!!!!

Jay Z. · Post by **Jay Z.** » Fri Jan 09, 2009 6:24 am

Looks good. :thumbsup2:

Dabeastwthn · Post by **Dabeastwthn** » Fri Jan 09, 2009 6:56 am

Looks really good! But "Needs more cowbell!" :biggrin:

luvmyhondas · Post by **luvmyhondas** » Fri Jan 09, 2009 10:21 pm

Fix the gap on the amp rack with another panel cutout to trim the amps. Make them flushmount, it will hide ALL the wires at the same time!