fuk fuk fuk

stlmadpanda · Post by **stlmadpanda** » Sat Jan 20, 2007 1:46 pm

I had a 6ft bar on mine while my fat ass was standing on it and still didnt pop loose. Finally had to drill it completelly off. hope you have better luck chris.

bildo16 · Post by **bildo16** » Sat Jan 20, 2007 5:17 pm

ive never had trouble with them. they normally come right off with a 1/2 impact.

SikofFalln · Post by **SikofFalln** » Sat Jan 20, 2007 9:23 pm

If you heat it up be carefull, it would be really easy to cook the bearings on that front hub.

freakchris03 · Post by **freakchris03** » Sun Jan 21, 2007 12:35 am

been here done all this...took a long ass breaker bar and lots of pb blaster..

deetz · Post by **deetz** » Sun Jan 21, 2007 12:41 am

chris, im gonna try to come over tomorrow when i take my car to stolle's if ya need my ginormous breaker bar lemme know,

magoo_lc1 · Post by **magoo_lc1** » Sun Jan 21, 2007 2:09 am

I hear you. Good luck with it though. My hatch is slowly using power. With a std there is not much to loose. I think the motor will shoot craps before jan. is over. Problem is short on funds right now. Trying to recover from the holidays. Dont know how ill get to school or work?

90CivicEx · Post by **90CivicEx** » Sun Jan 21, 2007 3:03 am

I got my bar if ya need it, also got a impact and the socket for the spindle nut. I got a compressor small enough but its like a 4 gallon and I don't think it will hit hard enough if you can't get it off with a breaker bar. But like I said we can try my bar if need be.

stlmadpanda · Post by **stlmadpanda** » Sun Jan 21, 2007 4:47 am

what ever you do good luck

Lotek · Post by **Lotek** » Sun Jan 21, 2007 5:10 pm

how bout freezing it with a compressed liquid? you may run into some brittleness issues, but it may shrink the bold enough to let it move.