Inner Tie Rods DIY?

mike93hatch · Post by **mike93hatch** » Thu Jun 04, 2009 10:49 pm

RyanA;183875 wrote:These are the special ones I usually use. The combination wrench has to be a special size so it's not too big and not too small. The Crescent, you just have to turn a little knob to make it feel special.

i have those exact same special tools!!! friggin lazy ass honda tech's

bildo16 · Post by **bildo16** » Thu Jun 04, 2009 10:54 pm

mike93hatch;183878 wrote:i have those exact same special tools!!! friggin lazy ass honda tech's

haha, when you do stuff flat rate, you invest in tools that get the job done efficiently and ones that save your knuckles.

IshbOO · Post by **IshbOO** » Thu Jun 04, 2009 10:56 pm

thanks for all the quick reposnes, I guess I will first try to remove the one on my shell to get some practice. If I cant seem to get it by the end of the weekend, I guess I might call up rickellsss

RyanA · Post by **RyanA** » Thu Jun 04, 2009 11:05 pm

bildo16;183880 wrote:haha, when you do stuff flat rate, you invest in tools that get the job done efficiently and ones that save your knuckles.

I hear you. However, when you can do it just as fast WITHOUT the specialty tools, what's the point of wasting the money? I have a few specialty tools that I have bought because they make the job easier; on a Honda, the inner tie rod tool is not one of them for me.

Capt'n Obvious · Post by **Capt'n Obvious** » Tue Jun 09, 2009 4:02 am

my friend brian has the tool im sure hell let you borrow or come by the house and do it

v-tecivic · Post by **v-tecivic** » Tue Jun 09, 2009 2:51 pm

these work amazing!! i've done both methods though.