camber kit in need!

IshbOO · Post by **IshbOO** » Thu Apr 10, 2008 1:43 am

my camber is horrible.

I'm looking on getting a camber kit.

I don't want to spend alot.

I was thinking Skunk 2 Classics in the front. 150
And Blox Rears. 100

The blox rears are like identical. but like 40$ cheaper. Although Blox front's are only 20$ cheaper, but look much less quality.

I think I can get this set up for around $250.

Anyone have any opinions? I have never bought an aftermarket camber kit on any car I have owned. But wanting to save my nittos!

Also Where can I have my car aligned? It is kinda low. I know one guy by fast lane. But I have to take my front bumper off to get on the rack. :/

Any info or opinions would be helpful. thanks alot!

Capt'n Obvious · Post by **Capt'n Obvious** » Thu Apr 10, 2008 3:00 am

IshbOO;108428 wrote:my camber is horrible.

I'm looking on getting a camber kit.

I don't want to spend alot.

I was thinking Skunk 2 Classics in the front. 150
And Blox Rears. 100

The blox rears are like identical. but like 40$ cheaper. Although Blox front's are only 20$ cheaper, but look much less quality.

I think I can get this set up for around $250.

Anyone have any opinions? I have never bought an aftermarket camber kit on any car I have owned. But wanting to save my nittos!

Also Where can I have my car aligned? It is kinda low. I know one guy by fast lane. But I have to take my front bumper off to get on the rack. :/

Any info or opinions would be helpful. thanks alot!

that setup sounds good and sears

xslickwhitetegx · Post by **xslickwhitetegx** » Thu Apr 10, 2008 3:46 am

Skunk2 makes good camber kits, I would stick w/ them.. classic or pro series, but of course the pro is better, I got my new pro series front camber on ebay for $90. Never installed it though..

Anyways on aligement there aare a few places that are spelized in lowered vericles but charge like $75 an hour. Can't remrmber where they are located but I know T rock went to one.

v-tecivic · Post by **v-tecivic** » Thu Apr 10, 2008 4:05 am

if your not slamming your car super low. dont even bother with the rear camber kit at all. you can go the the hardware store and get some grade 8 bolts that are slightly longer and some washers to adjust the rear camber. these would be the two bolts that go into the body on the rear upper control arms.

Capt'n Obvious · Post by **Capt'n Obvious** » Thu Apr 10, 2008 4:37 am

damn camber kit front and rear for my car is 35 bucks but it is just 4 bolts

Midori · Post by **Midori** » Thu Apr 10, 2008 5:13 am

i have skunk2 all around and have for a while now, i wouldnt buy anything else, except maybe the new Buddy club ones, i might give those a try in the future