diy tps adjustment

Capt'n Obvious · Post by **Capt'n Obvious** » Fri Sep 04, 2009 6:45 pm

i may have done this wrong so comment if i did

ok the tps is located on the throttle body and its super easy to adjust but very important

1. loosen the bolts holding it on

2. take your multimeter out and set it to volts

3. put the positive probe in the plug that the red wire goes in

4. set your key on the on position dont turn motor on

5. with the tb closed it should read .5 if it doesnt turn it back and fourth till it is
(mine does it oppisite for some reason)

6. at wot it should be around 4.5

thats it

now tighten that throttle cable it makes a world of difference

just for laffs

neighbors vette i drove

tibby finally finished

4Door · Post by **4Door** » Fri Sep 25, 2009 8:10 am

reset to .35/.40 closed

b18b1__hatch · Post by **b18b1__hatch** » Mon Sep 28, 2009 6:00 pm

this is how i was told to do it

Capt'n Obvious · Post by **Capt'n Obvious** » Wed Sep 30, 2009 1:08 am

4Door;200379 wrote:reset to .35/.40 closed

mine only goes to 4.0

4Door · Post by **4Door** » Wed Sep 30, 2009 8:41 pm

matt;201121 wrote:mine only goes to 4.0

"4.0" you say... do you mean .40..?

Capt'n Obvious · Post by **Capt'n Obvious** » Thu Oct 01, 2009 2:49 am

4Door;201254 wrote:"4.0" you say... do you mean .40..?

nope 4.0 wot cant go lower biiiiiiiiiiiiiiiitch
and .35 or so at idle remember bone said to turn it to 20 or somthing
with the wires switched