D16Y8 Bogging, help please

JustRob · Post by **JustRob** » Sat Nov 19, 2011 11:37 pm

The knock sensor is most likely not causing the issue you're having. But it's not helping you either. All DTC's and their causes need to be addressed and fixed before trying to diagnosis other issues. If you have an OBD2 scan tool and a list of code(s) the car has, I can help you a bit more.

getteg · Post by **getteg** » Sat Nov 19, 2011 11:44 pm

I dont have a scan tool.

but maybe I will throw some plates on it tomorrow and run up to the auto parts store. The only thing I got when I jumped the harness was 23.

getteg · Post by **getteg** » Tue Dec 06, 2011 2:08 am

Ok so no more CEL's. I have replaced the knock sensor since it was broken, drained all the year old fuel, and set the timing and I am still havin issues.

It also wants to die after I drive it and get on it, but only when I come to a stop.

JustRob · Post by **JustRob** » Tue Dec 06, 2011 2:13 am

getteg;280783 wrote:Ok so no more CEL's. I have replaced the knock sensor since it was broken, drained all the year old fuel, and set the timing and I am still havin issues.

It also wants to die after I drive it and get on it, but only when I come to a stop.

Did you check this like Rick mentioned?

rickles8099;279642 wrote:swap the tps sensor wire and the map sensor wire and then see what happens.

getteg · Post by **getteg** » Tue Dec 06, 2011 2:32 am

JustRob;280786 wrote:Did you check this like Rick mentioned?

I tried and the wires wont reach.

opntrk86 · Post by **opntrk86** » Tue Dec 06, 2011 1:32 pm

Maybe you don't have the wiring harness routed in the stock location. If you can loosen it somewhere to get the needed slack, it would still be worth a try.

Probably the most common problem after a swap, happen to me more that a few times