cam setting

noregretz · Post by **noregretz** » Fri Mar 11, 2011 1:18 am

im putting back together an h22 to put in my prelude. i was just wondering how i should set the cams back in the head.. im pretty sure you just make sure your marks point up but i wanted to make sure there wasnt anything special i need to do. any help or tips will greatly appreciated

Waffles · Post by **Waffles** » Fri Mar 11, 2011 1:27 am

Both arrows go up, but make sure the engine is at TDC first.

andyjt · Post by **andyjt** » Fri Mar 11, 2011 1:37 am

noregretz;258683 wrote:im putting back together an h22 to put in my prelude. i was just wondering how i should set the cams back in the head.. im pretty sure you just make sure your marks point up but i wanted to make sure there wasnt anything special i need to do. any help or tips will greatly appreciated

Make sure to set the Balancer shaft properly as well...

Waffles · Post by **Waffles** » Fri Mar 11, 2011 1:41 am

andyjt;258689 wrote:Make sure to set the Balancer shaft properly as well...

I hear those can be a bitch

noregretz · Post by **noregretz** » Fri Mar 11, 2011 4:35 am

any idea on how to actually do that? this is my first h series motor i have really worked on before.