ARP rod bolt ?

[Redline]

ok i am a little confused, i am putting arp rod bolts in my motor before i put it back together, but i have seen that you have to have the rods machined, the cap shortened and the big side bored, is this a must? or can i just install my arp rod bolts with no problems.

[Gunmetal Si]

if using the 8mm ones u do not. 9mm ones u do

[Redline]

if using the 8mm ones u do not. 9mm ones u do

stupid question but wanna do this right, so with these rod bolts
http://cgi.ebay.com/ebaymotors/ws/eBayI ... 2231wt_935
on my d15b i wont have to machine anything just install new bearing and rod bolts and will work fine