One Last Time y8 mani swap

bemberg2 · Post by **bemberg2** » Sat Jun 19, 2010 5:25 pm

This is the third time i've done this and keep having the same problems. I just wanted to make sure these were the holes i should be capping off. The smallest holes right above each port??????? THANKS

bemberg2 · Post by **bemberg2** » Sat Jun 19, 2010 6:59 pm

I'm just asking cause there is a vacuum leak and i think its coming from these holes. the gasket is solid, so its not that.

bemberg2 · Post by **bemberg2** » Sat Jun 19, 2010 8:26 pm

no one? midori you were the expert on this last time? any advice? thanks

Midori · Post by **Midori** » Sat Jun 19, 2010 8:54 pm

Those little holes on the face of the flange in front of each injector opening. Jb weld them shits closed. Cure for 24 hrs. Reinstall and you won't have a vaccum leak anymore

bemberg2 · Post by **bemberg2** » Sat Jun 19, 2010 8:56 pm

YES, thanks a ton. I just wanted to make sure before i took this thing apart again. thanks dude.