95 civic swap

coupe95 · Post by **coupe95** » Fri May 07, 2010 9:09 pm

just wswapped a b16 a2 out of a 99 si into my 95 civic that had a d16z6 how do i go about wiring the harness? is there an adapter i can get to hook up to my stock harness or from the b16 harness

90CivicEx · Post by **90CivicEx** » Fri May 07, 2010 10:15 pm

coupe95;231701 wrote:just wswapped a b16 a2 out of a 99 si into my 95 civic that had a d16z6 how do i go about wiring the harness? is there an adapter i can get to hook up to my stock harness or from the b16 harness

Ok so take your stock harness put it on the motor take the obd-2 harness off only wireing you should have to do is the distributer wireing from what I believe.

Chip your p28 that was in the car, to rock a obd-1 b16a tune.

coupe95 · Post by **coupe95** » Fri May 14, 2010 1:20 am

ok i got the stock harness all plugged up and still bneed to do the ditributer, got diagrams for it and that wont be a problem. i also ran into 3 to wire round clips that dont plug to ne thing and the alt clip connector is different but i can just switch connectors. i have a p28 chiped to dohc im not 100% sure if its for my motor tho my buddy said it was for a b16 so i guess that will work?

blueandy · Post by **blueandy** » Fri May 14, 2010 3:42 pm

I cant stand wiring, thats my one problem. Alot of people on here could probably help you and if you still cant figure it out, check out rywire.com

onecam12sec · Post by **onecam12sec** » Fri May 21, 2010 4:36 pm

If you don't want to mess with the wires. Give rywire a call. Get your answers straight from the source. I haven't used that ecu since 04-06 so it might need reprograming, or you can find a 93? 94-96 gsr ecu, they are obd1