z6 help

ls hatch · Post by **ls hatch** » Wed Nov 11, 2009 1:45 am

hello.. my buddy just traded for a civic.. it is a 93 hb.. im pretty sure the z6 didnt come in this car.. if anybody could help me id like to figure out what they had to do too get the swap in and and if the engine harness from a z6 will pug into the factory harness.. because they have the b7 distributer on the car.

JustRob · Post by **JustRob** » Wed Nov 11, 2009 3:14 am

The D16Z6 is an easy swap for the '92-'95 Civic DX/CX/VX. The motor will bolt right in using the D16Z6 mounts. The D16Z6 distributor and ECU are required for it to run right. As for wiring, we need to know what model your friend has. DX, CX or VX?

ls hatch · Post by **ls hatch** » Wed Nov 11, 2009 3:26 am

haha thanks.. but it doea ha e the b7 distibuter.. its held in by one bolt.. its stupid i know.. ill have to look deff. dont know what it is.. all badges are taken off.

JustRob · Post by **JustRob** » Wed Nov 11, 2009 3:28 am

Then you need to replace it with the right distributor...

ls hatch · Post by **ls hatch** » Wed Nov 11, 2009 3:40 am

im working on that.. we just got the car saturday.. and we have been putting in a transmission. and the flywheel and clutch

Capt'n Obvious · Post by **Capt'n Obvious** » Fri Nov 13, 2009 6:18 am

if it has rear disc it was stock

B16inside · Post by **B16inside** » Fri Nov 13, 2009 7:38 am

matt;208824 wrote:if it has rear disc it was stock

and in that case i assume si if the z6 was stock i dunno im tired its 130 i shouldnt even be replying.

but matt he said he thinks the z6 didnt come with car so i doubt it was stock i mean its his car i think he knows best.

B16inside · Post by **B16inside** » Fri Nov 13, 2009 7:48 am

ls hatch;208485 wrote:because they have the b7 distributer on the car.

an easy fix to that is find a z6 dizzy

problem solved

onecam12sec · Post by **onecam12sec** » Fri Nov 13, 2009 3:51 pm

look at the weight in driverside door. it should be like 3270 for si. also power sunroof. if not ,unless it's a vx(no side moldings or ps, and tach redline 6500), you will need to run wire for vtech, if not already done.

HardCore97 · Post by **HardCore97** » Fri Nov 13, 2009 8:06 pm

onecam12sec;208854 wrote:look at the weight in driverside door. it should be like 3270 for si. also power sunroof. if not ,unless it's a vx(no side moldings or ps, and tach redline 6500), you will need to run wire for vtech, if not already done.

none of the eg hatches weighed anywhere near 3270. if its an SI it will have a sunroof and rear disc like others have said. SI's came with the d16z6 from the factory