high idle

sharpie · Post by **sharpie** » Mon Aug 27, 2007 7:58 pm

all problems solved as of now just need safety and plates and the car will be back on the streets thank you guys for the help

Eric

4Door · Post by **4Door** » Wed Aug 29, 2007 4:03 am

what ended up being the problem???

sharpie · Post by **sharpie** » Wed Aug 29, 2007 12:20 pm

the problem was the iacv and i just cleaned it like 5 times and put some oil on the gasket like you said and that fixed the problem and the rattle was my exhaust the bolts that hold the cat to the header were loose. so thanks for the help

Eric

Silver Knight · Post by **Silver Knight** » Wed Aug 29, 2007 5:17 pm

glad to hear you fixed it Eric!

sharpie · Post by **sharpie** » Wed Sep 05, 2007 10:16 pm

new problem it serges at idle it goes up and down, and while driveing when i get on the gas it throws me back in the seat and when i let off it feels like i put the brakes on then the idel starts to go up and down again.

any help would be awsome
thanks
Eric

4Door · Post by **4Door** » Wed Sep 05, 2007 11:00 pm

hey sharp... have you checked for ane hoses that may have a hole or cut in it...

intake, pcv... you should also check you pcv valve...

sharpie · Post by **sharpie** » Wed Sep 05, 2007 11:04 pm

thanks holms

sharpie · Post by **sharpie** » Thu Sep 06, 2007 8:18 pm

i did a smoke test today to see if i could find a leak and all the smoke came out the air filter i also took of the iacv and cleaned it and put a little sealer on the gasket and the problem went away for a while like 15-20 min then it came back so i think i need a new iacv does anyone know
where i can get one cheap

4Door · Post by **4Door** » Fri Sep 07, 2007 6:40 am

sharpie;65135 wrote:i did a smoke test today to see if i could find a leak and all the smoke came out the air filter i also took of the iacv and cleaned it and put a little sealer on the gasket and the problem went away for a while like 15-20 min then it came back so i think i need a new iacv does anyone know
where i can get one cheap

yep, it prolly loses its seal when the IM gets hot... you can prolly just use some high temp silicone on it... also, check the rubber gasket for cracks/tares... the gasket isnt removable, it should be pinched on... if it is cracked or torn, it prolly wont be able to have a good seal...

Spork · Post by **Spork** » Fri Sep 07, 2007 7:20 am

I fixed a 4500 rpm idle today... Goddamn I hate the FITV