b series swap question

Drowzysleeper · Post by **Drowzysleeper** » Sun Apr 22, 2007 11:46 pm

i have an eg hatch that was converted from auto to manual. would i need a different mount for a b series engine? i was told i did, but my source wasnt completely reliable.

Spork · Post by **Spork** » Mon Apr 23, 2007 12:14 am

I believe the regular manual mounts will work for you, the chassis is the same between the auto and manual cars...

N2HIFI · Post by **N2HIFI** » Mon Apr 23, 2007 1:37 pm

but you will need a manual rear tranny mount from the 5-speed tranny

chris

5thgen · Post by **5thgen** » Mon Apr 23, 2007 2:45 pm

The auto mount location is a little different from the manual mount location. You can either buy a mount made for this, or drill out and weld in the factory manual mount location. If you have already done this part, then yes all you would need is the rear bracket.

Drowzysleeper · Post by **Drowzysleeper** » Mon Apr 23, 2007 5:32 pm

well im not following completely it was already converted from auto to manual. it was fine with the manual tranny in it. im just not sure if it will work with the bseries.