D series 4-2-1 manifold ?

Post by **budget_crx** » Fri Dec 15, 2006 7:20 am

Drowzysleeper;5261 wrote:arent the crx hf manifolds a 2 piece header?

all d series manifolds are 2 piece, but most are just 4 into 1, i need a 4-2-1

Drowzysleeper;5263 wrote:what about the old school integra? the have the d16a1 in them which is like the usdm zc.

yeah, but it was not a performance engine so it has the same 4 into 1 as most other d series

Drowzysleeper · Post by **Drowzysleeper** » Fri Dec 15, 2006 6:15 pm

o well im not sure then

Drowzysleeper · Post by **Drowzysleeper** » Fri Dec 15, 2006 6:16 pm

you could probably buy a used d series header for 50 bucks

Post by **stolle** » Fri Dec 15, 2006 11:11 pm

d16y8 has a similar setup 4-2-1 i saw it on a 96 civic...

91civicsi · Post by **91civicsi** » Sat Dec 16, 2006 5:56 am

88-89 integra gasket is the same, I just put one on my zc

Post by **budget_crx** » Sat Dec 16, 2006 7:23 am

stolle;5388 wrote:d16y8 has a similar setup 4-2-1 i saw it on a 96 civic...

thanks man, I just realised i didn't explain what i needed to well, but im glad you caught on

90CivicEx · Post by **90CivicEx** » Sun Dec 17, 2006 12:08 am

meh corey got the header off tonight...:drive: