D series 4-2-1 manifold ?

Post by **budget_crx** » Thu Dec 14, 2006 6:52 am

What USDM cars came stock with a 4-2-1 exhaust manifold? I need a gasket for my ZC manifold and can't remember which cars came with a similar setup
should look like this

the pic says Z6, but i didn't think they had em :dunno:

90CivicEx · Post by **90CivicEx** » Thu Dec 14, 2006 6:53 am

z6 had 4-1 I do believe but schmoe would know

90CivicEx · Post by **90CivicEx** » Thu Dec 14, 2006 6:54 am

shouldn't matter then cause a z6 manifold fits a a6 and what not, so you should be able to use any if thats the case

Post by **budget_crx** » Thu Dec 14, 2006 6:59 am

well i need to find out what car came with a similar manifold so i can order a gasket for it. not the gasket that goes to the head either, the one that seals the 2 pieces so not every d series manifold will work

90CivicEx · Post by **90CivicEx** » Thu Dec 14, 2006 7:30 am

ahhh, like I said gasket making material is the best lol

Spork · Post by **Spork** » Thu Dec 14, 2006 7:36 am

ghettOOO

but whatever works right? its not like its the only semi-ghetto part of this swap

Post by **budget_crx** » Thu Dec 14, 2006 5:30 pm

Spork;5155 wrote:ghettOOO

but whatever works right? its not like its the only semi-ghetto part of this swap

what part of this is ghetto?? the stock manifold is the best one in the us for ZCs

Spork · Post by **Spork** » Thu Dec 14, 2006 6:10 pm

no, not that... i'm sure the ZC manifold is better.

nevermind

Drowzysleeper · Post by **Drowzysleeper** » Fri Dec 15, 2006 3:07 am

arent the crx hf manifolds a 2 piece header?

Drowzysleeper · Post by **Drowzysleeper** » Fri Dec 15, 2006 3:13 am

what about the old school integra? the have the d16a1 in them which is like the usdm zc.