Fender Rolling and taking care of surface rust

Focke · Post by **Focke** » Thu Sep 15, 2011 3:09 pm

Ok so back in 01 I tried to roll my fenders with a baseball bat. In the end it cracked some of the paint off and did a shitty job bending the damned lip inwards. So my question to you guys is do you know anyone that can roll them for me completely AND what should I do to take care of the surface rust? I had the idea of just grinding it down and rhino lining that small lip to prevent rust from every forming again. It is just on the very surface as well its not deep or anything and I figure something like rhinolining would prevent o2 from getting in there.

Waffles · Post by **Waffles** » Thu Sep 15, 2011 3:14 pm

If the rust is not in a visible area, I would use something like POR 15 after doing some basic sanding/cleaning.

Focke · Post by **Focke** » Thu Sep 15, 2011 3:35 pm

Yea it would not be visible post it getting rolled the corret way. I mean you can scratch the damned stuff and see bare steel so its not bad, its just something that you can somewhat see until it gets rolled. Also, POR 15?

Waffles · Post by **Waffles** » Thu Sep 15, 2011 3:39 pm

I have friends that swear by the stuff. Its a rust converter.

www.por15.com

Focke · Post by **Focke** » Thu Sep 15, 2011 4:04 pm

Hmmmm that would work as well. Thing is I still need to find someone to roll the damned things fully/properly. Also, if its going to be invisible at that point, that is where I was considering the rhinoliner post the rust being ground off. Its not even bad whatsoever, I am jus ttrying to nip it in the bud before it gets bad.

Waffles · Post by **Waffles** » Thu Sep 15, 2011 4:08 pm

there is someone on here that has a real fender roller, but I dont remember their name.

gcef89 · Post by **gcef89** » Thu Sep 15, 2011 6:08 pm

por15 is really good its been keeping rust of my dads truck for a few years now!

JustRob · Post by **JustRob** » Fri Sep 16, 2011 12:49 am

Evo Terry rolled my fenders a couple years ago and did an awesome job. I'm not sure if he's still rolling fenders or not.

ymisoqt · Post by **ymisoqt** » Fri Sep 16, 2011 1:15 am

JustRob;274160 wrote:Evo Terry rolled my fenders a couple years ago and did an awesome job. I'm not sure if he's still rolling fenders or not.

He rolled the fenders on my sol in July, I think he's still doing it. And +1 on an awesome job.