Before and After S2000 Swap

andyjt · Post by **andyjt** » Thu Oct 04, 2007 12:21 am

Before:

After:

Even Further After:

After about $400 in OEM parts and sensors, and an hour or so with the sand blaster this is what i have. Still a lot of cleaning left. As well as replacing a bent rod

Gunmetal Si · Post by **Gunmetal Si** » Thu Oct 04, 2007 12:32 am

how did a rod get bent?????????

andyjt · Post by **andyjt** » Thu Oct 04, 2007 12:34 am

GUNMETAL SI;71007 wrote:how did a rod get bent?????????

The fire was put out with water. Not compltly sure if thats the case. I get about 95% of a full revolution then it locks the motor up and wont turn. Its not the valves. The engine locks up when the pistons are midway up the cylinders.

-andrew

Clayton · Post by **Clayton** » Thu Oct 04, 2007 12:55 am

so andy, what are your plans for this engine?

andyjt · Post by **andyjt** » Thu Oct 04, 2007 12:58 am

06sik20z3;71013 wrote:so andy, what are your plans for this engine?

putting it into a car you nOOb!

MLRtimeSTL · Post by **MLRtimeSTL** » Thu Oct 04, 2007 1:02 am

Looks good dude. I gave you a call last sunday or so about that harness. Give me a call back whenever you get a chance.

andyjt · Post by **andyjt** » Thu Oct 04, 2007 1:05 am

MLRtimeSTL;71016 wrote:Looks good dude. I gave you a call last sunday or so about that harness. Give me a call back whenever you get a chance.

dialing

MLRtimeSTL · Post by **MLRtimeSTL** » Thu Oct 04, 2007 1:11 am

andyjt;71017 wrote:dialing

Thanks dude. I will update you on your old teg when we meet up.

JZO6ETR · Post by **JZO6ETR** » Thu Oct 04, 2007 1:57 pm

Hmmm...Nice andy!! Can't wait to see what this goes in, i think i have an idea!

Keith · Post by **Keith** » Thu Oct 04, 2007 4:51 pm

Nice job Andy. The question is which car?

I have a spark plug cover if you want to replace yours Andy.

Keith