lurch's 95 hatch

lurch95hatch · Post by **lurch95hatch** » Sat Jun 16, 2012 7:34 pm

Finaly got the hatch finished and out of the garage, dropped it off to get the front end aligned, safety inspected and the ac charged. Plates are goin to be picked up on monday and she turns back into my daily driven instead of daily garaged. See you guys on the streets and hopefully at the meets, pics coming soon.

lurch95hatch · Post by **lurch95hatch** » Mon Jun 18, 2012 11:33 pm

Plates on today and rolling, gunna snap a few pics after I clean it. Probably will end up being the weekend. Thanks everyone who helped me out along the build and thank you for your interest in my thread.

95_gsrfodo · Post by **95_gsrfodo** » Sun Jun 24, 2012 4:25 am

sounds good cant wait to see new pix..

lurch95hatch · Post by **lurch95hatch** » Tue Jul 03, 2012 10:39 pm

Finaly in today is te new hid kit. And this time it a proper kit, a bi xenon kit with all the safety features. No more flickering no more blowing ballasts.

Anything Honda · Post by **Anything Honda** » Fri Jul 06, 2012 10:21 am

Everything is looking good can't wait to seen more :drunk:

Andrew · Post by **Andrew** » Fri Jul 06, 2012 7:11 pm

I really like this hatch man, I miss mine.

lurch95hatch · Post by **lurch95hatch** » Thu Jul 12, 2012 4:12 am

Anything Honda;296944 wrote:Everything is looking good can't wait to seen more :drunk:

Andrew;296966 wrote:I really like this hatch man, I miss mine.

Thanks guys! Now thanks to Rick and Chris I have pin-pointed my reverse light issue and also got a new ac condensor coil, now to hook it up and charge it. Then it's just the rake master cylinder and the o2 sensor left and (fingers crossed) its finished for now. Stay tuned for more updates!

lurch95hatch · Post by **lurch95hatch** » Sat Jul 14, 2012 10:09 pm

Well today I installed the new hid kit and it works like a champ, kinda weird to have high beams again.

Remove the old leaking master cylinder and replaced that junk

Also I replaced the o2 sensor in hopes of getting close to that 30+ mpg. And thank you Rick for the condenser coil, installed and ready to be recharged.

lurch95hatch · Post by **lurch95hatch** » Wed Aug 08, 2012 4:14 am

So in the last couple weeks my clutch was acting up. Had a real bad shudder and was having sparatic shifting difficulties. So I ripped the old one out to take a look at it.

This is what I found

And looked at the clutch cover and the flywheel and found scoring and gouging

So I purchase these guys

And noticed a fairly bad leak on the oil pan gasket, which should be here tomorrow. Once it gets here it time to replace the gasket and instal the new clutch kit. We shall see how this goes.

Andrew · Post by **Andrew** » Wed Aug 08, 2012 4:23 am

nice upgrade! When you have the flywheel off, make sure your rear main isnt leaking. Would be better to fix it while its all apart (if it is bad)

I have a used Exedy laying around I'll be using in my Acura.