something different (no baller) haters welcome

Midori · Post by **Midori** » Sun Nov 08, 2009 5:06 pm

bag -o- suck.

matt-just get different wheels? that is the obvious problem stated by the population here.

Capt'n Obvious · Post by **Capt'n Obvious** » Mon Nov 09, 2009 5:28 am

i had a flat tire today so ordered 2 new ones
also while idling i noticed my car was over heating well the o2 sensor wire got caught in the fan and it ripped it out so the fan could not spin then say water spewing out of one of the heater hoses because the clamp was not on

so after a gallon of water putting the clamp on and untangling the wire from the fan it was fine

B16inside · Post by **B16inside** » Mon Nov 09, 2009 4:31 pm

jpciii · Post by **jpciii** » Tue Nov 10, 2009 4:31 am

holy crap, that's pretty funny. Glad it's working again but get some antifreeze in there. Winter is coming!

Capt'n Obvious · Post by **Capt'n Obvious** » Wed Nov 11, 2009 3:49 am

but water is so much cheaper lol
it was not working for like 10 minutes thank vishnu bri was there and gave me a hand

Edison Carasio · Post by **Edison Carasio** » Wed Nov 11, 2009 7:01 pm

FYI, I stopped reading at page 6.

If you swapped in the GSR leather seats, it would be cool if you saved up and reupholstered the rear in leather.

I think if you could get some OEM wheels or Enkei RPF 1's on it, that would make it look good IMO. EM1 ten spoke wheels would be nice. Some CRX swirlies would make it time appropriate, which would flow with the ZC swap.

Good springs, different wheels, the ZC swap, leather rear seats and a good sound system would make this nice and clean. Keep on working on it, and just do what you want in the end. Maybe you'll like some ideas you're given, maybe you wont.

Capt'n Obvious · Post by **Capt'n Obvious** » Wed Nov 11, 2009 7:33 pm

i for got to mention i put in es shifter bushings

Capt'n Obvious · Post by **Capt'n Obvious** » Mon Nov 16, 2009 2:44 am

b16 tb thanks to bri and intake thanks to tommygun in
es motor mount inserts on the way
thanks especially to rob for teaching me to solder a different way among other things and how to check ecu codes and help me get rid of my cel/ starting/ full throttle problem alot quicker now that i can go more than 80 percent throttle

ksingh2463 · Post by **ksingh2463** » Sat Nov 28, 2009 1:46 am

yeah... wheels are too big for such a small car with no power

Capt'n Obvious · Post by **Capt'n Obvious** » Sun Nov 29, 2009 3:14 am

spark plugs changed there was no o rings between the spark plug things and valve cover
and getting some new wheels super secret but after someon buys my steelies