wire relocation (oh yeah i forgot 56k or something)

xslickwhitetegx · Post by **xslickwhitetegx** » Sat Sep 13, 2008 12:29 am

g3integragsr;136070 wrote:looks good man, try working on your camera skills

+1 and clean your damn engine bay b4 you take pics..

kra95civic · Post by **kra95civic** » Sat Sep 13, 2008 10:51 pm

matt;136014 wrote:why do you think i have not done that yet i figured that out

ok noted then fix your post..........

Capt'n Obvious · Post by **Capt'n Obvious** » Thu Sep 18, 2008 2:49 am

another update

i have had so much shit going on its rediculous but squeezed in time to do some more wiring

mad pics
before (doesent show too much of what i moved)

made a bracket for my cb

did more tucking and relocating

moved the throttle cable and the criuse control dealy and injector wiring

MyfodoSi · Post by **MyfodoSi** » Thu Sep 18, 2008 9:38 am

Lookin good. Now clean 'er.

singleslammer · Post by **singleslammer** » Thu Sep 18, 2008 1:53 pm

When you tucked the Throttle cable, did you check to make sure that it wasn't going to catch on anything. Happened to me once. that is some scary stuff when you can't get the car to stop from going faster. Also, make sure that your injector wiring isn't touching anything that gets hot. It will eat through the loom eventually and that isn't any fun either.

Capt'n Obvious · Post by **Capt'n Obvious** » Fri Sep 19, 2008 1:29 am

singleslammer;136924 wrote:When you tucked the Throttle cable, did you check to make sure that it wasn't going to catch on anything. Happened to me once. that is some scary stuff when you can't get the car to stop from going faster. Also, make sure that your injector wiring isn't touching anything that gets hot. It will eat through the loom eventually and that isn't any fun either.

found this out on mlk bridge i was just chillin at 6k for like 10 seconds b/t shifts then put it in third and pushed the brake and finagnled the throttle till it came loose parked at the next gas station and fixed it.

singleslammer · Post by **singleslammer** » Fri Sep 19, 2008 1:51 pm

ouch, when it happened to me I ended up over revving the car by about 2.5K. not good since it was a Ford 3.8L v6. uuhhhh...pushrods (shudder)