89 CRX Si Project...

90CivicEx · Post by **90CivicEx** » Fri Apr 20, 2007 12:45 am

Pretty much I don't wanna bore, sleeve, stroke a B16a I wanna do a B18a bored, stroked and sleeved to a 2.0 which is like a CRVtec in a way but I'm gonna use High compression pistons and Eagle rods and go from there.

Deetz send me a pic, If your interested then we might be doing something cause I'm gonna wet sand this one this weekend and smooth it out and respray the red cause theres a few minor blemish's.

deetz · Post by **deetz** » Fri Apr 20, 2007 2:08 am

there no dings or dents or shit in it, it was joshs old bronze one, but the powder coat job sucked so i restripped it, itl be uncut, but bare

90CivicEx · Post by **90CivicEx** » Fri Apr 20, 2007 3:05 am

deetz;37278 wrote:there no dings or dents or shit in it, it was joshs old bronze one, but the powder coat job sucked so i restripped it, itl be uncut, but bare

Un cut? Are you talking about the one AJ had that showed the cam gears cause thats what I'm looking for later down the road. Anyways if ya could just snap a shot of it right quick and send me it that'd be the best so I could decide what to do.

deetz · Post by **deetz** » Fri Apr 20, 2007 3:09 am

yea the timing part is uncut, i have one with the whole cover cut off too, its on my caR at the moment, il snap pics tomorrow mornin,

90CivicEx · Post by **90CivicEx** » Fri Apr 20, 2007 3:13 am

werd sounds good y0, If we do this do you want it how it is all painted or do you want the honda emblem and D.O.H.C Vtec part polished?

deetz · Post by **deetz** » Fri Apr 20, 2007 3:15 am

dude do what ya want, il trade ya both my covers if ya polish the lettering

90CivicEx · Post by **90CivicEx** » Fri Apr 20, 2007 3:23 am

deetz;37290 wrote:dude do what ya want, il trade ya both my covers if ya polish the lettering

It would take me like 10 minutes lol, I'm seriously gonna try and get those blemishes out of it though before we trade. It's just a few spots where the paint just thinned out on me but it was prolly cause I was spraying in a cold area and letting it start to dry and takeing it and setting it next to the heater to bake it on.