Time for progress

92_luder · Post by **92_luder** » Fri Jan 06, 2012 2:51 pm

N2HIFI;282874 wrote:most of your issues seem related to the swap

- check and make sure the reverse wires at the tranny are hooked up (prob why your lights dont work)

- does the sruise power up (green light) if it does but dosnt work it may be the brake wire or the clutch switch for the cruise is bad ...easy fixes

- if your running a ls ecu with a ls harness then you wont throw any codes, mainly because the ecu dosnt know that there is a vtec head on the motor... but when you put in a vtec ecu on the ls harness you will throw codes... you need a p72 or p28 chipped for a gsr then pin the ecu for vtec and run wires to the vtec solenoid after that then your ecu should work fine... Or just buy a vtec controller lol

these are all simple issues common with a swapped car

Cruise doesn't light up at all wen I press the button and its wired for vtec. I used a friend p28 and vtec engaged at 5grand like it should.

N2HIFI · Post by **N2HIFI** » Fri Jan 06, 2012 5:39 pm

92_luder;282897 wrote:Cruise doesn't light up at all wen I press the button and its wired for vtec. I used a friend p28 and vtec engaged at 5grand like it should.

cruise may just not be plugged in, im not using my set up on my car so if you want to try my cruise stuff let me know ill pull it off so you can try it out

and it just sounds like you need a gsr ecu then (dont use a stock p28... dosnt have the fuel maps for a b series)

92_luder · Post by **92_luder** » Fri Jan 06, 2012 10:02 pm

N2HIFI;282924 wrote:cruise may just not be plugged in, im not using my set up on my car so if you want to try my cruise stuff let me know ill pull it off so you can try it out

and it just sounds like you need a gsr ecu then (dont use a stock p28... dosnt have the fuel maps for a b series)

i was thinkn about that too...so should i jus buy a p28 get it chipped and tuned and hold on to the ls ecu in the meantime?

92_luder · Post by **92_luder** » Fri Jan 06, 2012 10:03 pm

andyjt;282879 wrote:I asked you this before in your other thread. Im pretty sure it was an old car of mine. Double check. Is/Was this car an Auto originally?? If its my/my friends old one like im 99% sure the Reverse lights arent wired up after the auto-manual swap.

im thinkn it is cuz wen i had it in the air the exhaust was kinda messy where the linkage connects...and the pedal looks wierd to me....but i could b crazy

andyjt · Post by **andyjt** » Fri Jan 06, 2012 11:59 pm

92_luder;282944 wrote:im thinkn it is cuz wen i had it in the air the exhaust was kinda messy where the linkage connects...and the pedal looks wierd to me....but i could b crazy

PM Me the last few digits of the vin so i can verify. Or feel free to call if you have any questions.
314-807-2587
-Andrew

Turtle_Civic · Post by **Turtle_Civic** » Sat Jan 07, 2012 12:03 am

N2HIFI;282924 wrote:cruise may just not be plugged in, im not using my set up on my car so if you want to try my cruise stuff let me know ill pull it off so you can try it out

and it just sounds like you need a gsr ecu then (dont use a stock p28... dosnt have the fuel maps for a b series)

Listen to this man or you'll be putting a motor in.

92_luder · Post by **92_luder** » Fri Jan 13, 2012 6:22 pm

Turtle_Civic;282951 wrote:Listen to this man or you'll be putting a motor in.

i know. the chip kit for the p28 jus arrived.....so until its soldered and a basemap is put on i wont b using it.