What did you improve on your car this week?

crazysol · Post by **crazysol** » Wed May 18, 2011 12:21 am

el this and el that should be incredible

RyanA · Post by **RyanA** » Wed May 18, 2011 3:07 am

Got the suspension on my 4 door. Bilstein/Neuspeeds, SPC front upper camber/caster arms, EM1 control arms and front sway, Skunk2 rear control arms, ASR rear brace, ITR rear sway, Wicked rear toe, SPC rear camber. Got the alignment done today, too. Only driven it from the alignment shop home but it seems to drive pretty nice.

N2HIFI · Post by **N2HIFI** » Wed May 18, 2011 5:13 am

i drove the piss out of my 240 at Nashville super speed way (where Import alliance is held at), BUT the power steering pump went out prior to the event ... SO ill be replacing this soon

RBs93 · Post by **RBs93** » Wed May 18, 2011 6:56 am

my biggest improvement was buying my car, lol. 98 bb6
pics tomorrow after i do some clean up on her.

STLMUGEN · Post by **STLMUGEN** » Wed May 18, 2011 9:38 am

I install a sweet stlhonda's sticker, good for 10 hps!:bling:

crazysol · Post by **crazysol** » Thu May 26, 2011 2:40 pm

Threw my old carbon hood away.

onecam12sec · Post by **onecam12sec** » Thu May 26, 2011 7:54 pm

did an oil change today. vacuumed it. now i need newer axles, and another b16 tranny, since i somehow managed to loose 3rd gear.

STLMUGEN · Post by **STLMUGEN** » Fri May 27, 2011 10:32 pm

Where did you put last? LOL

RyanA · Post by **RyanA** » Sat May 28, 2011 3:29 pm

Ordered a few more new parts for my 4 door

CT-Engineering (CompTech) IceBox
Yonaka cat back (I think I like the sound of these better than the WS2/SP2 and they are WAAAAY cheaper)
OBD2B-OBD1 conversion harness (already had a 2b to 2a but now need to go OBD1..)
REAL high flow cat (not a simulated cat) and the flanges to bolt it to the HyTech rep header and the cat back.
Innovate LC-1

Probably be ordering an S300 on Tuesday along with the display for it. Plan on flushing the display in front of the cup holders at this time. If I go TunerView 2, I'll just put it where the pocket goes below the radio behind a piece of tinted plexi. All I need after that is some smaller saturated injectors (need 310's, have RC 370's right now) and I think I'll be in business.

Have all of the parts for my ITR front brakes to go on so they'll go on this coming week. Redrilled rotors, calipers, milled abutment brackets, braided lines, pads, and hardware. Also have the ITR booster and master cylinder to put on the car.

It's coming along nicely. Hoping to have this pile of trash D series out in the next couple weeks.

gcef89 · Post by **gcef89** » Sat May 28, 2011 4:09 pm

took my old halo projector headlights out took the 30k hid kit out put it all back to stock