What did you improve on your car this week?

2ksi · Post by **2ksi** » Wed Apr 13, 2011 4:51 am

All B&M products: short throw, FPR, and fuel gauge.

twkdcd595 · Post by **twkdcd595** » Wed Apr 13, 2011 12:09 pm

Ordered a M&W pro10 ignition, ps92 coil, and t1 mil spec pro10 harness. Naturally from T1. Leaving the last big piece to get once I have some more funds or if any of my parts ever sell... 1600cc or 2000cc injectors.

Waffles;261459 wrote:just needs a oil pan

LOOKING GOOD!!! Cant wait to hear that beast when you get it back in the car. brap brap brap brap. :rock:

fry;261524 wrote:Fixed an ic pipe so when I throw bunches moar boost it won't pop off. Fixed my big oil leak. All that's left is put in injectors,new plugs,map sensor and fill it up with e85

Very nice... good to hear you finally got that leak to stop.

99PreludeSh · Post by **99PreludeSh** » Thu Apr 14, 2011 4:46 pm

I put the new axle seals in and put everything back together. just need to buy the transmission fluid and I'll be good to go.

Redline · Post by **Redline** » Fri Apr 15, 2011 3:49 am

4door gsr teg got new axle and brakes and the hatch got a walbro 255 and in the works of a tune but hit fuel cut

sharpie · Post by **sharpie** » Fri Apr 15, 2011 5:16 am

Drove that fucker. Put like 45miles on it. It was nice having it out and about again

2ksi · Post by **2ksi** » Fri Apr 15, 2011 5:30 am

finally got my walbro 255 in!

andyjt · Post by **andyjt** » Fri Apr 15, 2011 5:34 am

sharpie;261755 wrote:Drove that fucker. Put like 45miles on it. It was nice having it out and about again

+1! It was nice driving mine after being stored up all winter!

Post by **budget_crx** » Fri Apr 22, 2011 1:42 am

New rotors, will be installed once the pads arrive.

sirricealot · Post by **sirricealot** » Fri Apr 22, 2011 2:15 pm

got a new tire so i can drive it more than 10 miles with more than 5psi of air in it lol.

crazysol · Post by **crazysol** » Fri Apr 22, 2011 2:23 pm

Installed my si cluster

Also installed ASR subframe brace, rear tow package, and bennen bar. (LCA's, rear sway, and rear disc conversion in the works)

Passed inspection for new plates

Barn-yard Built