What did you improve on your car this week?

crazysol · Post by **crazysol** » Mon Aug 02, 2010 2:36 pm

Just got back from vacation to find a new motor has been delivered to the house. Its so clean and ready for install.

Lynxs1981 · Post by **Lynxs1981** » Mon Aug 02, 2010 11:03 pm

Started tearing down the tranny to replace the broken clutch case.

Edison Carasio · Post by **Edison Carasio** » Sun Aug 08, 2010 5:33 am

The Fit - Cleaned air filter (or was that last week? lol)
CRX - Rick tightened up hub/spindle nut or whatever that was causing loose wheel bearing. Had outter tie rod replaced.

lilryan · Post by **lilryan** » Sun Aug 08, 2010 9:49 pm

put on itr rear sway and asr subframe brace

JustRob · Post by **JustRob** » Mon Aug 09, 2010 3:21 am

Bought a GSR block to start building

Waffles · Post by **Waffles** » Mon Aug 09, 2010 3:21 am

JustRob;241328 wrote:Bought a GSR block to start building

What???

JustRob · Post by **JustRob** » Mon Aug 09, 2010 3:23 am

Waffles;241329 wrote:What???

I'll have a motor ready for when the Jetta sells so I can pick up where I left off.

SikofFalln · Post by **SikofFalln** » Mon Aug 09, 2010 4:37 am

JustRob;241330 wrote:I'll have a motor ready for when the Jetta sells so I can pick up where I left off.

Nice!

Took the crap ass window tint off the back hatch glass (still have to do the rear quarter glass).

Replaced the dryer and the expansion valve on the A/C, cleaned the exchange, and replaced all the foam seals. In the next day or two going to vacuum out the system and give it a fresh charge so I will have some cold A/C again.

4Door · Post by **4Door** » Mon Aug 09, 2010 6:02 am

92'
A/C went out a few weeks ago (so much for an improvement)

98'
tightened up all the sub-frame bolts - no more pops and creaks when going up/down the drive way...

fixed a factory flaw on the SRP competition fuel rail i robbed from my B-16... they never drilled the hole for the FPR all the way threw, so it would just keep building pressure... pretty sure its why the guy drove on it for 20 miles then pulled it and i ended up with it for $250

that, and the AEM cam gears were out of wack...

i think im going to pull it apart and give it a refresh (rings, bearings, hone, etc;) and install the GSR cams, then finally put it in and pull the tired Ls out... ehhh, who knows...

Martin · Post by **Martin** » Mon Aug 09, 2010 5:13 pm

Got a 98 rear bumper and Spoon oil cap. Ordered new a Spoon rear strut tower brace. Installed my new Spoon blue rearview mirror.